Advanced-protection XCS Instrukcja Użytkownika Pobierz pdf

NEC

Article 285 & UL 1449-3

SPD Types: Types 1, 2, 3, & 4

Based on Location within electrical distribution system

(also coincides with ANSI/IEEE C62.41.2 - 2002 Categories C, B &A)

▪Only qualied licensed electricians should install or service SPDs

▪SPDs should never be installed or serviced when energized or during electrical storms

▪Use appropriate safety precautions including Personal Protection Equipment

▪Failure to follow these instructions can result in death, serious injury, and/or

equipment damage

▪When used in outdoor applications, customer must seal the conduit nipple using

watertight ttings (not included) to ensure a watertight connection

▪Read this manual in its entirety prior to installing

WARNING

– Risk of Electric Shock

Installation, Operation

& Maintenance Manual

(800) 237-4567

(727) 535-6339

Fax (727) 539-8955

Advanced Protection Technologies

www.aptsurge.com

[email protected]

14550 58th Street North

Clearwater, Florida 33760

UL is a registered trademark of Underwriters Laboratories, NEC

and National Electrical Code are

registered trademarks of National Fire Protection Association, C62.41.1-2002, C62.41.2-2002,

C62.45-2002, C62.72-2007 are registered trademarks of IEEE.

7.9.13.lh #8078

European Authorized Representative

Obelis s.a.

Boulevard Général Wahis 53

1030 Brussels, BELGIUM

Tel: +(32) 2. 732.59.54

Fax: +(32) 2. 732.60.03

E-Mail: [email protected]

ENGLISH

Thank you for choosing an APT XCS Surge Protective Device (SPD). The XCS is a high quality, high

energy surge suppressor designed to protect sensitive equipment from damaging transient overvoltages.

The XCS is parallel connected such that circuit ampacity is unlimited. Proper installation is important to

maximize performance. Please follow steps outlined herein. These instructions are not intended to replace

national or local codes. Follow all applicable electrical codes to ensure compliance.

UL 1449 Third Edition (Sept 2009) and 2008

NEC

Article 285 generated substantial

changes regarding SPDs.

The XCS complies with latest regulatory

actions and is UL 1449 Listed as such

(VZCA.E321351). There is new emphasis on

installation location, identied as Types 1, 2,

3 and 4, outlined below.

SPD Types (see 2008 NEC

Article 285 and/or UL 1449-3):

Type 1: Installation on the line side or load side of the service

disconnect overcurrent device and may be used in Type 2 or Type

4 installations. Examples: surge arrestors, lightning arrestors,

meter hubs, metering cabinets, ran out of breaker positions, etc..

Type 2: Downstream of service disconnect; probably will

connect via breaker. Examples: switchboards, power panels,

panelboards, equipment, motors, pumps, etc.

Type 3: Plug-in SPD

Type 4:

Usually treated as a UL Recognized component in a larger

UL Listed nished product. Examples: UL 508 control panels, medical

equipment, wind turbines, signage, conveyers, elevators, etc.

TEXCS Series

Surge Protective Device (SPD)

1 2 3 4 5 6 7 8

Podsumowanie treści

Strona 1 - XCS Series

NEC® Article 285 & UL 1449-3SPD Types: Types 1, 2, 3, & 4Based on Location within electrical distribution system(also coincides with ANSI/IEEE

Strona 2 - INSTALLATION

INSTALLATIONPre-Plan your installation. You need to accomplish the following: ▪ Meet all National and Local codes (NEC® Article 285 and UL 1449 addres

Strona 3 - Specications

The XCS is a Type 1 SPD. The XCS is suitable for use almost anywhere (not as a plug-in SPD). Type 1 SPDs are evaluated more rigorously by UL 1449 for

Strona 4 - ▪ Normally Open:

4SPDs on Ungrounded SystemsCaution – Ungrounded systems are inherently unstable and can produce excessively high line-to-ground voltages during certai

Strona 5 - Operación & Mantenimiento

Manual de Instalación, Operación & Mantenimiento ▪ Sólo Electricistas calicados autorizados podrían instalar o dar servicio a un DPS ▪ Un DPS nun

Strona 6 - ADVERTENCIA

INSTALACIÓNPlanique con anterioridad su instalación. Usted debe tener en cuenta lo siguiente: ▪ Busque todas las Normas Nacionales y Locales (NEC® Ar

Strona 7 - Especicaciones

Figura 43.00".183"7.91"7.41"∅.201"2.21" 3.00"DIMENSIONES Y PESO3El XCS es un DPS Tipo 1. El XCS es adecuado para se

Strona 8 - ▪ Normalmente

CABLES4DPSs en Sistemas sin puesta a tierra Cuidado – Los sistemas sin puesta a tierra son intrínsecamente inestables y pueden producir excesivos alto

Komentarze do niniejszej Instrukcji

Brak uwag

Advanced-protection XCS Instrukcja Użytkownika

Przeglądaj online lub pobierz Instrukcja Użytkownika dla Akcesoria elektryczne Advanced-protection XCS. Advanced Protection XCS User Manual Instrukcja obsługi

Podsumowanie treści

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Akcesoria elektryczne Advanced-protection XCS